Anritsu MS9740A - Display[:Window]:Trace:y1[:Scale]:Blevel

Chapter 3 Message Details
3-204
:DISPlay[:WINDow]:TRACe:Y1[:SCALe]:BLEVel
Function
The command sets the level scale to the linear and sets the Linear Level
value.
This command queries the linear Level value.
Syntax
:DISPlay[:WINDow]:TRACe:Y1[:SCALe]:BLEVel
<numeric>[MW|NW|PW|UW|W]
:DISPlay[:WINDow]:TRACe:Y1[:SCALe]:BLEVel?
<numeric>:
● The units for absolute value display are from 1 pW to 1 W as follows:
MW:mW, UW:
µ
W, NW:nW, PW:pW,W:W
If the units are omitted, W is assumed.
● When the scale is displayed in relative values (%), the Linear Level
value cannot be set.
Response Data
<numeric>: Linear Level value (W)
Example of Use
:DISPlay:WINDow:TRACe:Y1:SCALe:BLEVel 50UW
:DISPlay:WINDow:TRACe:Y1:SCALe:BLEVel?
>+5.00000000E-005