Anritsu MS9740A - Calculate:parameter[:Category]:Pmd

Chapter 3 Message Details
3-146
:CALCulate:PARameter[:CATegory]:PMD
Function
This command sets the parameters and performs PMD application
analysis.
This command queries the parameters for the PMD application.
Syntax
:CALCulate:PARameter[:CATegory]:PMD
<numeric>[DB],<switch>,[<numeric>]
:CALCulate:PARameter[:CATegory]:PMD?
No.
Parameter Type
Range
Description
1
<numeric>
0.01 to 1.00 dB
Res. 0.01 dB
Mode Coupling factor (dB)
If a suffix is omitted, the
unit will be dB.
2
<switch>
0|1
Selecting measurement
method
0: Auto 1: Manual
3
<numeric>
2 to 99
Res. 1
Peak Count
Measurement method 0: can
be omitted when Auto is set.
Response Data
<numeric>,<switch>,[<numeric>]
No.
Parameter Type
Description
1
<numeric>
Mode Coupling factor (dB)
2
<switch>
Selecting measurement method
0: Auto 1: Manual
3
<numeric>
Peak Count
Example of Use
:CALCulate:PARameter:CATegory:PMD 0.8,1,8
:CALCulate:PARameter:CATegory:PMD?
>+8.00000000E-001,1,8