Anritsu MS9740A - Calculate[1|2|3|4|5|6]:Average[:State]

Chapter 3 Message Details
3-38
:CALCulate[1|2|3|4|5|6]:AVERage[:STATe]
Function
This command sets the Trace Storage Mode to Average.
This command queries whether the Trace Storage Mode is Average.
Syntax
:CALCulate[1|2|3|4|5|6]:AVERage[:STATe] 0|1|OFF|ON
:CALCulate[1|2|3|4|5|6]:AVERage[:STATe]?
Specify the Active trace (A to F) by specifying a number from 1 to 6.
When omitted, the Active trace is not changed.
0|OFF: Turns off the Storage Mode—Average.
1|ON: Turns on the Storage Mode—Average.
Response Data
0|1
Example of Use
:CALCulate3:AVERage:STATe OFF
:CALCulate3:AVERage:STATe?
>0