Anritsu MS9740A - SRE [Service Request Enable]

Chapter 3 Message Details
3-30
*SRE [Service Request Enable]
Function
This command sets the service request enable register.
The setting of 0 to 255 is equivalent to 8-bit binary.
The status byte register mask bit is set to 0.
This command queries the service request enable register value.
Syntax
*SRE <numeric>
*SRE?
<numeric> = bit0 + bit1 + bit2 + bit3 + bit4 + bit5 + bit6
+ bit7
bit7 : 2
7
= 128
Not used
bit6 : 2
6
= 64
Always 0
bit5 : 2
5
= 32
Standard event status register
bit4 : 2
4
= 16
MAV
bit3 : 2
3
= 8
Error event register
bit2 : 2
2
= 4
End event register
bit1 : 2
1
= 2
Not used
bit0 : 2
0
= 1
Not used
Range 0 to 255
Example of Use
The following example shows how to mask bits 7, 6, 1, and 0 and permit
bits 5 and 2.
*SRE 60
*SRE?
>60