Anritsu MS9740A - Page 46

Chapter 2 Before Use
2-30.
Using
:STATus:EVENt:CONDition?
The commands in Table 2.6.3-1 set bit of the end event register when
execution is completed.
The following messages are sent after confirming the completion of
execution when reading the end event register using
the :
STATus:EVENt:CONDition
? query.
Examples of Use:
*CLS
Sets OPC bit to 0
:INIT
Performs single measurement
:
STAT:EVEN:COND?
Queries end event register
> 0
Executing command when 0 read
:
STAT:EVEN:COND?
Queries end event register
> 2
Not executing command and SSI
execution completed when 1 read
:CALC:PAR:CAT:SMS
R 2NDPEAK
Executes spectrum analysis by SMSR.
:STAT:EVEN:COND?
Queries end event register
> 0
Executing command when 0 read
:STAT:EVEN:COND?
Queries end event register
> 1
Spectrum analysis by SMSR completed
when 1 read.
:CALC:MARKer1:MAX
Executes peak search
:
STAT:EVEN:COND?
Queries end event register
> 0
Executing command when 0 read
:
STAT:EVEN:COND?
Queries end event register
> 1
Peak search completed when 1 read
:CALC:MARK1:Y?
Queries trace marker data