Anritsu MS9740A - Page 152

Chapter 3 Message Details
3-106
Response Data
<switch>,<switch>,<switch>,<numeric>,…,<numeric>
No.
Parameter type
Description
1
<switch>
0:NF(S-ASE)
1:NF(Total)
2
<switch>
0: Spect Div Off: Spectrum division off
1: Spect Div On: Spectrum division on
2: PLZN Nulling: Polarization nulling
3: Pulse Method: Pulse method
4: WDM Measure: WDM measurement
3
<switch>
0: Gauss Fitting ASE Level found by Gauss
method
1: Mean Fitting ASE Level found by averaging
value
4
<numeric>
Fitting Span (m)
Wavelength range for calculating ASE level
5
<numeric>
Masked Span (m)
Wavelength range excluded from ASE level
calculation
Set a small value than Fitting Span.
6
<numeric>
Pin Loss (dB)
Optical signal level loss correction coefficient
7
<numeric>
Pout Loss (dB)
Optical signal level loss correction coefficient
8
<numeric>
NF Calibration
Noise figure correction coefficient
9
<numeric>
O.BPF Level Calibration (dB)
Optical filter loss correction coefficient
10
<numeric>
O.BPF Band Width (m)
Optical filter passsband width
11
<numeric>
Pol Loss (dB)
Polarization controller loss correction coefficient
Example of Use
:CALCulate:PARameter:CATegory:AMP:PARameter
0,2,0,20NM,2NM,0,0,1,0,30NM,0
:CALCulate:PARameter:CATegory:AMP:PARameter?
>0,2,0,+2.00000000E-008,+2.00000000E-009,+0.00000000E+00
0,+0.00000000E+000,+1.00000000E+000,+0.00000000E+000,+3.
00000000E-008,+0.00000000E+000