Anritsu MS9740A - Page 317

Appendix A Message Codes
A-5
Appendix
Appendix A
Table A-5 Operation-Related Codes (200 to 299)
Code Meaning
200
Execution error
210
Operation prohibited during measurement.
211
Operation prohibited during Auto Measure.
212
Operation prohibited while Power Monitor displayed.
213
Operation prohibited at Peak Search or Dip Search.
214
Invalid In Sweep-Average.
215
Operation prohibited while Ext.Trig. displayed.
216
Operation prohibited at Calibration.
217
No Write-Trace
220
Operation prohibited at Analysis.
221
Operation prohibited when Application selected.
221
Setting conflict.
222
Character string too long.
222
Input value out of range.
222
Operation prohibited when WDM Application selected.
223
Operation prohibited when Opt.Amp Application selected.
224
Operation prohibited when Auto PMD selected.
225
Operation prohibited when Pulse Method or WDM Method in Opt. Amp
Application is selected.
226
Operation prohibited when Spectrum Power is selected.
227
Operation prohibited when Peak/Dip Search is not performed.
228
Operation prohibited when Area specified as Noise Detection Type.
230
Operation prohibited when Normalize Disp displayed.
231
Operation prohibited when Zone Marker displayed.
Turn Zone Marker off.
232
Set Span larger than 0.
233
Operation prohibited at frequency unit Change unit from frequency to
wavelength.
235
Operation prohibited at Linear Scale.
Change Linear Scale to Log Scale.
236
Option Error(**)
238
Operation prohibited when Calculation set for Trace Type.
Change Trace Type to setting other than Calculation.
239
Set Display of Active Trace to On.
240
Selected TCP Port Number busy.
Change TCP Port Number.
241
Storage Mode enabled only when Write set for Trace Type of active trace
242
Calculation enabled only when calculation set for Trace Type of active trace
243
Trace measurement parameters must be same to calculate between traces.
244
Trace already in use
245
Invalid wavelength
246
Pase enabled only when PLZN Nulling set for Method.