Datalogic MAGELLAN 900i - In-Store Printed Label Minimum Read

OTHER UPC/EAN OPTIONS ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE 131
In-Store Printed Label Minimum Read
This feature specifies the minimum number of consecutive In-Store Printed Label decodes
before is accepted as good read.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar-
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode barcode.
In-Store Printed Label Minimum Read = 1
In-Store Printed Label Minimum Read = 2
In-Store Printed Label Minimum Read = 3
In-Store Printed Label Minimum Read = 4
DEFAULT
008501(CR)
008502(CR)
008503(CR)
008504(CR)