PRODUCT REFERENCE GUIDE
309
MOUNTING HOLES
There are six mounting holes located on the KIOSK mount flange. The recommended size
for the screws is 3mm. See
Mounting Template on page 311 for a 1:1 template drawing of the
mounting holes.
INTEGRATING THE SCANNER BEHIND A WINDOW
It is not recommended to place any type of additional window between the scanner and
the bar code to be read. The addition of a host enclosure window will significantly degrade
scanner performance. This is due to the additional reflective surfaces that will cause optical
interference with the imaging.
SCANNER CLEARANCE FOR INTEGRATION
To avoid damaging the M900i scanner by accidental impact or Electro Static Discharge,
maintain 10mm/0.38” in clearance between the scanner and any other items in the cus-
tomer enclosure (except front mounting surface).
To Next Page
Loading...
