3 - 214
Chapter 3 Removal and Replacement Procedures (RRPs)
Version 2 2007.03.20
Replacement 66 OPERATOR PANEL (PL13.2.97)
9) Replace the LATCH FRONT to the FRONT COVER together with the PLATE LATCH by
mating the left and right side slits of the LATCH FRONT with the studs on the FRONT
COVER.
10) Secure the left and right sides of the LATCH FRONT to the FRONT COVER using the two
screws (silver, with flange, tap, 10mm).
11) Anchor the SPRING LATCH to the hole on the PLATE LATCH and the peg on the FRONT
COVER.
When performing the step described below, pay attention to the direction of installation.
Replace the BUTTON TOP so that its thicker half comes behind and its top fits flush with
the right side of the COVER FRONT ASSY.
12) Secure the BUTTON TOP to the FRONT COVER with the two hooks.
Continues to the next page.
Gnb03215KA
10)
9)
12)
10)
11)
Front
Side
Rear
Side
NOTE
To Next Page
Loading...
