166 Configuring System Information
Figure 6-53. TACACS+ Servers Table
Removing a TACACS+ Server from the TACACS+ Servers List
1.
Open the
TACACS+ Settings
page.
2.
Click
Show All
.
The
TACACS+ Servers Table
opens
.
3.
Select a
TACACS+ Servers Table
entry.
4.
Select the
Remove
check box.
5.
Click
Apply Changes
.
The TACACS+ server is removed, and the device is updated.
Configuring TACACS+ Servers Using CLI Commands
For information about the CLI commands that perform this function, see the
TACACS+ Commands
chapter in the
CLI Reference Guide
. The following table summarizes the equivalent CLI commands you
use.
Table 6-30. TACACS+ Servers Commands
CLI Command Description
key Specifies the authentication and encryption key for all TACACS
communications between the device and the TACACS server.
port Specifies a server port number.
priority Specifies the order in which servers are used.
show tacacs Displays TACACS+ server settings and statistics.
tacacs-server host Specifies a TACACS+ server host.
tacacs-server key Sets the authentication and encryption key for all TACACS+
communications between the switch and the TACACS+ daemon.
tacacs-server timeout Sets the interval for which the switch waits for a server host to reply.
timeout Specifies the timeout value in seconds.
To Next Page
Loading...
