Dell PowerConnect 8024 - Page 287

Configuring Switching Information 287
• MAC ACL Name — Specifies an existing MAC ACL. To set up a new MAC ACL use the MAC ACL
Configuration page.
•
Rule Id — Selects or creates a user-defined ACLs. Enter an existing Rule ID, or create a new one by
selecting Create from the drop-down menu and entering the desired new Rule ID in the field next to
it. The new ID is created once Apply Changes is clicked.
•
Action — Selects the ACL forwarding action, which can be one of the following values:
–
Permit — Forwards packets which meet the ACL criteria.
–
Deny — Drops packets which meet the ACL criteria.
•
Assign Queue ID — Click the check box to apply this criteria, then enter an identifying number from
0 to 6.
•
Redirect Interface — Select from the drop-down list of interfaces one that packets meeting this rule
can be redirected to.
•
Mirror Interface — Select from the drop-down list an interface that packets meeting this rule can be
mirrored to.
•
Logging — Click the check box to enable logging for this ACL. This feature is supported for the Deny
action only.
•
Match Every — Requires a packet to match the criteria of this ACL. Click the check box to apply this
criteria.
•
Class of Service — Requires a packet’s CoS to match the CoS value listed here. Click the check box
and enter a CoS value between 0 and 7 to apply this criteria.
•
Secondary CoS — Requires a packet’s secondary CoS to match the CoS value listed here. Click the
check box and enter a CoS value between 0 and 7 to apply this criteria.
•
Destination MAC Address — Requires a packet’s destination port MAC address to match the address
listed here. Click the check box and enter an address to apply this criteria.
•
Destination MAC Mask — Enter the MAC Mask associated with the Destination MAC to match.
•
EtherType — Requires a packet’s EtherType to match the EtherType listed here. Click the check box
and select from a list or enter the EtherType ID:
–
Select from List — Select desired EtherType from the drop-down menu.
–
Match to Value — Enter the desired port number to match.
•
Source MAC Address — Requires a packet’s source port MAC address to match the address listed
here. Click the check box and enter an address to apply this criteria.
•
Source MAC Mask — If desired, enter the MAC mask for the source MAC address to match.
•
Vlan Id — Requires a packet’s VLAN ID to match the ID listed here. Click the check box and enter
the VLAN ID to apply this criteria. Possible field values are 1–4095.
•
Remove — Removes the MAC ACL Rule when Remove is checked and Apply Changes is clicked.