Dell PowerConnect 8024 - Page 288

288 Configuring Switching Information
Modifying a MAC-based Rule
NOTE: Rules can be modified only when the ACL to which they belong is not bound to an interface.
1. Open the MAC ACL Rule Configuration page.
2. Select the desired ACL from the MAC ACL drop-down menu.
3. Select the desired rule from the Rule ID drop-down menu.
4. Modify the remaining fields as needed.
5. Click Apply Changes .
The MAC-based rule is modified, and the device is updated.
Adding a New Rule to a MAC-based ACL
1. Open the MAC ACL Rule Configuration page.
2. Select the desired ACL from the MAC ACL drop-down menu.
3. Specify Create New Rule for Rule ID .
4. Enter a new ID number.
5. Define the remaining fields as needed.
6. Click Apply Changes .
The new rule is assigned to the specified MAC-based ACL.
Removing a Rule From a MAC-based ACL
1. Select an ACL.
2. Select a rule from the Rule ID drop-down menu.
3. Check the Remove check box.
4. Click Apply Changes .
The MAC-based ACL is removed, and the device is updated.
Configuring MAC-based ACLs Rules Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide :
• ACL Commands
The following table summarizes the equivalent CLI commands you use to define a MAC ACL.