400 Configuring Switching Information
Figure 7-94. LLDP Configuration
The LLDP Configuration page contains the following fields:
Global Settings
•
Transmit Interval (1–32768)
— Specifies the interval at which frames are transmitted. The default is
30 seconds.
•
Hold Multiplier (2–10)
— Specifies multiplier on the transmit interval to assign to TTL. Default is 4.
•
Re-Initialization Delay (1–10)
— Specifies delay before a re-initialization. Default is 2 seconds.
•
Notification Interval (5–3600)
— Limits the transmission of notifications. The default is 5 seconds.
Port Settings
•
Interface
— Specifies the port to be affected by these parameters.
•
Transmit Mode
— Enables or disables the transmit function. The default is disabled.
•
Receive Mode
— Enables or disables the receive function. The default is disabled.
•
Transmit Management Information
— Enables or disables transmission of management address
instance. Default is disabled.
•
Notification Mode
— Enables or disables remote change notifications. The default is disabled.
To Next Page
Loading...
