EasyManua.ls Logo

Dell PowerConnect 8024 - Page 672

Dell PowerConnect 8024
778 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
672 Configuring Quality of Service
Subnet Mask
— The subnet mask of the destination IP address. This field is required when
Destination IP Address
is checked.
Source L4 Port
— Requires a packet’s TCP/UDP source port to match the port listed here. Select one
of the following options:
Select From List
— Click to select from a list of well known source ports to which packets are
matched.
Match to Port
— Click to add a user-defined Port ID to which packets are matched. Range is 0-
65535.
Destination L4 Port
— Requires a packet’s TCP/UDP destination port to match the port listed here.
Select one of the following:
Select From List
— Select from a list of well known destination ports to which packets are
matched.
Match to Port
— Click to add a user-defined Port ID to which packets are matched. Range is 0-
65535.
Protocol
— Requires a packet’s protocol to match the protocol listed here. Select one of the following:
Select from List
— Select from the drop-down list of protocols.
Match to Protocol ID
— Enter a protocol ID to which packets are matched. Range is 0-255.
EtherType
— Requires a frames’ Ethertype to match the Ethertype listed here. Select one of the
following:
Select from List
— Select from the drop-down list of EtherTypes.
Match to Value
— Enter an Ethertype ID to which packets are matched. Range is 0600-FFFF.
Class of Service
— Requires a packet’s Class of Service (CoS) for incoming packets to match the CoS
entered here. Range is 0-7.
Source MAC Address
— Requires a packet’s Source MAC Address for incoming packets to match the
address entered here.
Source MAC Mask
— Specifies the Source MAC address wildcard mask. Wild card masks determine
which bits are used and which bits are ignored. A wild card mask of 00.00.00.00.00.00 indicates that no
bit is important. A wildcard of FF:FF:FF:FF:FF:FF indicates that all bits are important. This field is
required when
Source MAC Address
is checked.
Destination MAC Address
— Requires a packet’s Destination MAC Address for incoming packets to
match the address entered here.
Destination MAC Mask
— Specifies the Destination MAC address wildcard mask. Wild card masks
determine which bits are used and which bits are ignored. A wild card mask of 00.00.00.00.00.00
indicates that no bit is important. A wildcard of FF:FF:FF:FF:FF:FF indicates that all bits are
important. This field is required when
Destination MAC Address
is checked.
VLAN ID
Requires a packet’s VLAN ID for incoming packets to match the VLAN ID entered here.
Range is 0-4095.

Table of Contents

Other manuals for Dell PowerConnect 8024

Related product manuals