Safety Tips
Chapter 1: Introduction
Isolette® Infant Incubator (Model C2000) Service Manual Page 1 - 21
1
SHOCK HAZARD:
Do not expose the unit to excessive moisture. Personal injury or
equipment damage could occur.
CAUTION:
When using the variable height adjustable pedestal stand, always lower
the incubator to its lowest position prior to transport for optimum
stability. Failure to do so could result in personal injury or equipment
damage.
CAUTION:
Replace both oxygen sensor cells at the same time. Failure to do so
could result in equipment damage.
CAUTION:
When reconnecting the rear panel connectors, connect the sensor
module-to-connector cable assembly to the sensor module connector
only. Do not connect the sensor module cable to the RS-232
connector. Equipment damage could occur.
CAUTION:
Always replace Nylok®
1
screws; do not reuse them. Equipment
damage could occur.
CAUTION:
Use caution when lowering the shell assembly in place on the shell
bottom. Ensure that no cables are pinched and that the extrusion
bumper fits properly. Failure to do so could result in equipment
damage.
CAUTION:
Do not use harsh cleansers, such as scouring pads or heavy-duty
grease removers or solvents, such as acetone. Equipment damage
could occur.
1. Nylok® is a registered trademark of Nylok Fastener Corporation.
To Next Page
Loading...
Need help?
General
