GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
3-36 Section 3-4 - Preparing for Installation
PRELIMINARY
3-5-1-3 HP 5400K DeskJet Color Printer
This only applies to HP K5400 models which are supplied pre-installed with the appropriate
software drivers. The DeskJet Color Printer can be connected to either of the USB ports (upper or
lower) on the rear connectors panel.
One must use the additional power source to activate the DeskJet Color Printer. However, this must
be powered from the scanner itself, via one of the isolated peripheral power outlets provided on the
system. A special power cable and AC adaptor are provided with the printer, enabling connection
of the printer to the peripherals outlet.
The DeskJet Color Printer can be connected once the system is powered ON, or after shutdown.
For instructions on:
- Configuring the printer, see ‘Configuring the HP 5400K DeskJet Color Printer for Connection
via USB Port” on page 3-37.
- Setting the HP K5400 as the default printer, see ‘Setting the HP 5400K DeskJet Color Printer
as the Default Report Printer” on page 3-40.
NOTE: After connecting the printer to the Vivid S5 N/ Vivid S6 N system, proceed to the following procedures,
as required:
• ‘Configuring Printing Buttons P1 and P2” on page 3-27
• ‘Setting Printing Orientation (Portrait or Landscape) and Paper Size” on page 3-33
IMPORTANT During Stand-by mode, it is NOT recommended to introduce or remove USB
devices; this may cause the system to lock-up during the boot-up procedure.
Figure 3-33 DeskJet Color Printer
DO NOT ATTEMPT TO USE A DIFFERENT TYPE OF DESKJET COLOR PRINTER
(BRAND OR MODEL) OTHER THAN THE DESKJET COLOR PRINTER PROVIDED BY
GE. THE ULTRASOUND SYSTEM IS AN EXTREMELY SENSITIVE AND COMPLEX
MEDICAL SYSTEM. ANY UNAUTHORIZED PERIPHERALS MAY CAUSE SYSTEM
FAILURE OR DAMAGE!
To Next Page
Loading...
