GE Vivid S6 N - 8-3-8-4 Rear Handle Installation Procedure; 8-3-8-4-1 Installing Handles Glued in Position; 8-3-8-4-2 Installing Handles Secured with Mounting Screws

GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
8-58 Section 8-3 - Control Console Components Replacement Procedures
PRELIMINARY
8-3-8-4 Rear Handle Installation Procedure
8-3-8-4-1 Installing Handles Glued in Position
NOTE: Identify the left and right rear handle before starting this procedure.
1.) Apply the RTV 102 silicone sealant to a few points along the aluminium bar.
2.) Slide the left handle onto the aluminium bar pushing it until it meets the aluminium T-joint.
3.) Repeat step 1 and step 2 to install the right handle.
4.) Allow the glue to dry overnight.
5.) Next morning, check that the handles are properly secured.
8-3-8-4-2 Installing Handles Secured with Mounting Screws
1.) Identify the left and right handle before starting the procedure.
2.) Slide the left handle onto the aluminium support bar and then secure it by replacing the mounting
screw (previously removed).
3.) Repeat step 2 to install the right handle.
Figure 8-72 Exploded View Showing Rear Handles - (New-type System)
Left handle
Mounting screw
Right handle
Mounting screw