GE Vivid S6 N - 4-3-4 Back End Processor Tests; 4-3-4-1 USB Test; 4-3-4-2 Standby Test

GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 4 - Functional Checks 4-37
PRELIMINARY
4-3-4 Back End Processor Tests
4-3-4-1 USB Test
4-3-4-2 Standby Test
NOTE: This test only applicable for Vivid S5 N or Vivid S6 N systems with a battery.
Table 4-22 Scanner USB Functional Test
Step Task Expected Result(s)
1
Plug the service dongle (Technical Support plug) into
one of the USB ports on the Operator panel, or on the
rear.
2
Turn ON the Vivid S5 N or Vivid S6 N scanner. The red LED on the service dongle illuminates.
3
Move the service dongle between each of the four USB
ports in turn, checking that the LED illuminates correctly.
The red LED on the service dongle illuminates.
Table 4-23 Standby Test
Task Expected Result(s)
1
Press the On/Off button on the control console for no
more than 3 seconds and select Standby.
The system enters Standby mode.
2
Turn OFF the system’s circuit breaker.
The system remains in Standby mode, indicated by the
On/Off button LED.
3
Turn ON the system’s circuit breaker.
Press the On/Off Button.
The system returns quickly to the Power-ON state - less
than 30 seconds.
4
Turn OFF the system’s circuit breaker. Press the On/Off
button for 1 sec. The system enters Standby mode.
Turn ON the system’s circuit breaker.
The system enters Standby mode and stays in this
mode. The On/Off button LED is steadily illuminated.
5
Turn OFF the system’s circuit breaker.
Press the On/Off button for 8 seconds.
The system enters the Power-OFF state. The On/Off
button LED is OFF.