GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
3-192 Section 3-9 - Completing the Installation Paperwork
PRELIMINARY
Section 3-9
Completing the Installation Paperwork
NOTE: On completion of a Vivid S5 N or Vivid S6 N ultrasound scanner installation, it is important to record the
relevant System Installation details (see Table 3-7 below) and Product Locator Installation details (see
Figure 3-219 on page 3-193), for future reference.
3-9-1 Installation Acceptance Test Criteria
A Vivid S5 N / Vivid S6 N ultrasound scanner is ready for use after the system has been configured
successfully in accordance with the information provided in Chapter 3 (this chapter).
3-9-2 System Installation Details
Enter the serial number printed on the main label (refer to the Product Labels and Icons section, on
page 1-18), and the other relevant system installation details into the following table:
3-9-3 Product Locator Installation
NOTE: During and after installation, the documentation (i.e. User Manuals, Installation Manuals...) for the
peripheral units must be kept as part of the original system documentation. This will ensure that all
relevant safety and user information is available during the operation and service of the complete
system.
1) Verify that all details have been entered in the System Installation Details form, as described in the
System Installation Details section, above. If this form has not been completed, enter the details
now.
2) Locate the Product Locator Installation Card(s) that are affixed to the monitor and to each of the
peripherals, and fill in all details on both the front and back of the card(s) - see Figure 3-219 on
page 3-193.
Note: Step 2 may have been completed already by GE personnel.
The Product Locator Installation Card shown in Figure 3-219 may not be identical to the
card(s) provided.
Table 3-7 System Installation Details
System S/N:
Location:
Date:
Customer Name:
Service Engineer’s Name:
Comments:
To Next Page
Loading...
