GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
3-174 Section 3-4 - Preparing for Installation
PRELIMINARY
8) Click OK to close the message.
The exam is now listed in the MPEGVue Patient List (see Figure 3-202 below) and is ready for
selection and viewing.
Note: When viewing the examination which has been received from e-mail, a separate instance
of MPEGvue application is opened, dedicated only for one e-mail examination. If you were
previously viewing different MPEGvue Patient exams, you will need to switch over to the
previous instance of the MPEGvue.
Receiving and Viewing a Partial Examination
In the event that the exam is large and a group of e-mails is expected, it is possible to view a partial
exam, even before all of the e-mail messages have arrived.
In addition, if an e-mail message is lost or corrupted, the contents of the remainder of the received
messages is available for review.
After receiving even one e-mail message out of many that have yet to arrive, simply select the new
examination in the MPEGVue Screen. The screen display will show voids or missing thumbnail images
in all places relating to the e-mail messages that have not yet arrived.
View previous exams from E-mail
1) From the MPEGVue Startup Menu, click on the View previous exams from email button.
The Patient List is displayed, listing all exams received by email:
2) Click on the required examination Exam Date (labeled 1 in the example above) to select and
display images of that exam.
The MPEGVue screen is displayed as shown in the example in Figure 3-185 on page 3-162.
Figure 3-202 MPEGVue Patient List
Figure 3-203 MPEGVue Patient List
To Next Page
Loading...
