GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
8-246 Section 8-8 - Software Loading
PRELIMINARY
6) When done, click somewhere outside the name. The name will then be changed.
7) Record the Volume’s name on a sticker or a piece of paper and attach it to the drive so that it will
be easier to locate the correct drive in the future.
8) Use the “Safely Remove Hardware” tool in the Task Bar before continuing with the next step.
9) Disconnect the USB cable from the laptop or PC.
8-9-4-7 Connecting the External USB Hard Disk to the Vivid S5 N or Vivid S6 N Scanner
1) Connect the USB cable to a USB port on the Vivid S5 N or Vivid S6 N scanner.
2.) Turn ON power to the Vivid S5 N or Vivid S6 N ultrasound scanner.
3) Under My Computer (refer to Figure 8-279 on page 8-245), verify that the drive appears for
selection.
4) Proceed to perform the following functionality test:
- “External USB Hard Disk Test” on page 4-34
To Next Page
Loading...
