GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
8-182 Section 8-6 - Lower Section Components Replacement Procedures
PRELIMINARY
2.) Disconnect the two power cables (seen in Figure 8-233) from the AC Box by squeezing the plastic
retainer clips inwards (Figure 8-234).
3.) Disconnect both ground leads.
4.) To remove the AC Box, unscrew the two supporting screws (shown in Figure 8-233) and slide the
AC Box all the way out until is completely removed from the system.
5.) Remove the Peripherals AC Outlet Connectors Panel, as described in the “Peripherals AC Outlet
Connectors Panel Removal Procedure” on page 8-167.
6.) Disconnect the AC cable from the AC Distribution Box, then disconnect the Printer AC Cable.
7.) Remove the ground lead from the AC Distribution Box - keep ready for reuse on the new
AC Distribution Box (as described in the following installation procedure).
8-6-16-4 AC Distribution Box (Type B) Installation Procedure
1.) Fasten the ground lead (previously disconnected from the AC Distribution Box that has been
removed) to the new AC Distribution Box - as illustrated (on left) in Figure 8-231.
2.) Place the Type-B AC Distribution Box in position at the rear of the system chassis by sliding it onto
the support rails and pushing it in all the way to the end.
Figure 8-229 AC Distribution Box Secured with Two Supporting Screws
Figure 8-230 Plastic Securing Clips on Power Cables
Disconnect
Two
Power Cables
AC Box
Supporting Screws
Ground Leads
To Next Page
Loading...
