GE Vivid S6 N - 8-9-2-5 DVD;CD-RW Installation Procedure

GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
8-238 Section 8-8 - Software Loading
PRELIMINARY
8-9-2 DVD/CD-RW Drive Replacement Procedure (cont’d)
8-9-2-5 DVD/CD-RW Installation Procedure
1.) Carefully place the replacement DVD /CD-RW Drive into the compartment. Slide it all the way in,
making sure it is properly seated against the rubber bumper at the rear of the compartment.
Note: When connecting the new USB cable, ensure that the USB connector is plugged into the
vacant USB port on the chassis i.e. the port that was previously occupied by the old DVD/
CD cable.
2.) Connect the new DVD cable as follows:
3.) Plug the D-type connector into its connector on the Vivid S5 N/Vivid S6 Nchassis - see
Figure 8-272.
Figure 8-272 D-type Connector Plugged into the Vivid S5 N/Vivid S6 N System
D-type connector plugged
into DIB J23 port