GE Vivid S6 N - 8-4-9-5 Releasing an Extended Keyboard Key

GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
8-84 Section 8-3 - Control Console Components Replacement Procedures
PRELIMINARY
8-4-9-5 Releasing an Extended Keyboard Key
1.) Using a sticky strip (e.g. masking tape or scotch tape), remove the key as follows:
2.) Clean and prepare the plastic key socket, as follows:
a.) Cover the key hole with a strip of plastic tape (sellotape) as shown in Figure 8-99.
Figure 8-98 Removing a Jammed Key from the External Keyboard
Figure 8-99 Key Hole Covered with Plastic Tape
a) Adhere the sticky strip to the key
b) Pull the key up
c) Key removed