GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-85
PRELIMINARY
b.) Remove any surplus plastic tape gently with sharp tool (e.g. scalpel or similar) - Figure 8-100.
Note: Pay attention not to damage the key surface or the painted lettering.
c.) Using air, gently clean inside the key hole to remove any shaved plastic edges.
d.) Remove the plastic tape from the key hole.
3.) Return the key to its correct position on the extended keyboard.
Figure 8-100 Removing Surplus Plastic Tape
To Next Page
Loading...
