GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-33
PRELIMINARY
8-3-2-4 Monitor Arm Installation Procedure
1.) Return the lower washer to its position on the securing pin - Figure 8-38.
2.) Position the monitor arm on the securing pin and return the upper washer to its position - refer to
Figure 8-38.
3.) Place the spacer washers on the securing pin in the order shown in Figure 8-39 (right to left).
Note: Pay attention to the middle spacer-washer set - these are concave and must be placed as
shown in Figure 8-40.
Figure 8-38 Positioning Upper and Lower Washers
Figure 8-39 Spacer Washers
Figure 8-40 Middle Space Washer Set
To Next Page
Loading...
