GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 3 - System Setup 3-167
PRELIMINARY
The E-mail Dialog box is displayed.
2) Activate the Send Current Image radio button, then click Next.
Note: If it is necessary to send the MPEGVue Player software to the recipient, first complete this
procedure, then proceed to ‘Sending the MPEGVue Player Software by E-mail” on page 3-168.
The E-mail address window is displayed.
3) Select an existing recipient address from the drop-down menu, or type a new address in the
Send To field.
Note: Up to 10 addresses can be stored for future selection.
4) Click Next.
The E-mail (addressed to the selected addressee) with the image is sent to the Outbox; during this
operation a progress window is displayed:
Figure 3-191 E-mail Dialog Box
Figure 3-192 E-mail Address Window
Figure 3-193 Sending Message to Outbox Progress Window
To Next Page
Loading...
