GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-73
PRELIMINARY
3.) Secure the Trackball Housing using the three new nuts supplied with the kit (see Figure 8-87).
4.) Carefully re-connect the two cables (previously disconnected), as indicated in Figure 8-89.
5.) Re-fit the Keyboard Bottom Cover, as described in the “Keyboard Bottom Cover Installation
Procedure” on page 8-60.
6.) Install the Keyboard Assembly on the system, as described in the “Keyboard Assembly Installation
Procedure” on page 8-42.
7.) Place the trackball into position in the Operator Panel.
8.) Return the trackball ring and turn to secure the trackball in its housing.
9.) Turn ON power to the system.
10.)Set the correct trackball speed to 5 (as previously noted) - see “Trackball Speed Setting” on page 6-9.
11.)Proceed to perform the following functionality tests:
- “Alphanumeric Keyboard Test” on page 4-18
- “Extended Keyboard and Trackball Test” on page 4-18
- “Speakers Tests” on page 4-21
- “Light Detector Test for Vivid S6 N only” on page 4-22
- “USB Test” on page 4-37
- “Grounding Continuity” on page 10-23
- “Chassis Current Leakage Test” on page 10-24
To Next Page
Loading...
