GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
8-214 Section 8-8 - Software Loading
PRELIMINARY
6. Proceed with the Software Installation process by
selecting the following option:
Load Installation
then press <Enter>.
Note: In the event that the Service Tools option had
been selected, you would be prompted for a Password.
This would then provide access to the following:
Check System ID - shows current system version etc.
Change System ID - do not touch!
InitNetwork - (for future use only)
Command Prompt - (for future use only)
File loading starts. While in progress, the following screen is displayed:
When complete (after approximately 10 minutes), the following message is
displayed prompting you to select the required option:
7. Select the following option:
Full Clean Install (System + Application +
Documentation)
then press <Enter>.
The following Warning message is displayed:
8. Press [Yes] to continue. The following message is displayed, providing the option to reboot the system
manually (if preferred) when software installation complete:
Table 8-2 Step-by-Step Software Upgrade/Installation/Reinstallation Procedure (cont’d) 2 of 9
Step Instruction Expected Result
To Next Page
Loading...
