164
────────────────────────────────────────────────────
7.12 Arbitrary Setting of Voltage Axis Magnification/ Compression and Display Range
────────────────────────────────────────────────────
Method Screen: CHANNEL 2
1. Press the CHAN key to call up the
CHANNEL 2 screen.
2. Use the
CH SELECT key to open selected
channel screen.
3. To use the variable function, move the
flashing cursor to the desired channel, as
shown in the figure on the left.
4. Use the function keys to make the selection.
: Variable function is disabled.
: Variable function is enabled.
5. Move the flashing cursor to the position
shown in the figure on the left, and set the
lower and upper limits.
The setting can be made in two ways.
To Next Page
Loading...
