Hioki 8835-01 - Page 31

9
────────────────────────────────────────────────────
1.3 Identification of Controls and Indicators
────────────────────────────────────────────────────
1
2
3
4
5
6
7
8
9
1
0
1
1
1
2
1
3
1
4
1
5
1
6
Printer
AC POWER switch Serves to turn the unit on and off.
Functional ground Connects to the earth.
terminal (GND)
AC connector The supplied power cord must be plugged in here.
Input unit slots These slots accept input units.
Analog input connector (on ANALOG UNIT) Unbalanced analog input
Ventilation slots
Fastening screw Secures the plug-in unit.
Trigger connectors Can be used to synchronize multiple units, using the
EXT TRIG input and TRIG OUT output.
KEY LOCK switch When this switch is set to ON, all keys of the 8835-01
are inactive. The key lock condition is maintained also
when the power is switched off and on again.
External start/stop Start and stop operation can be controlled via external
terminals signals.
External print/ Controls printing or sampling via external signals.
sampling terminal Switches automatically with time axis range settings.
NG evaluation output When the waveform evaluation based on waveform
terminal parameters has resulted in NG, a signal is output from
this terminal.
GO evaluation output When the waveform evaluation based on waveform
terminal parameters has resulted in GO, a signal is output from
this terminal.
DC power supply Allows use of an external DC source to power the unit
connector (with dedicated DC POWER ADAPTER).
Ground terminal Common GND (
3
Function ground terminal) with the
(GND) 8835-01. Use with
11
to
14
terminals.