289
────────────────────────────────────────────────────
13.4 Storing, Retrieving and Deleting Data on the Floppy Disk or PC Card
────────────────────────────────────────────────────
NOTE
NOTE
NOTE
4. Move the flashing cursor to the position
shown in the figure on the left, and use the
function keys to select the channel for storing
data.
: Channel number up
: Channel number down
Select ALL to save all displayed channels.
Undisplayed channels are not saved.
5. Move the flashing cursor to the position
shown in the figure on the left, and enter the
file name (see Section 9.5.5).
6. Press the (exec) function key.
To save the waveform data in the specified
format, press the
F1 (Yes) key. To abort
saving, press the
F2 (No) key.
If the A/B cursors are used, partical save is
applied.
Entering the file name
Select from file name entry options in function key display.
Enter: Type in name.
File list: Characters highlighted with line cursor are entered as file name.
Title: Comment in title comment is entered as file name.
Start up: Name for auto setup function is entered as file name.
Method
1. Move the flashing cursor to File name.
2. Each pressing of the
F3 function key display
selected file name entry.
When selecting file list, use the cursor key to
move the line cursor to select file.
: Switches entry selection.
3. Press Character Entry in function key display
to rename file. (see Section 9.5.5.)
・When loading comment in title comment as file name, first 8 characters are
entered as file name.
・When name for auto setup function is entered as file name, extension is not
attached. Extension apporpriate to file Category is attached during save.
To Next Page
Loading...
