NOTE
2. LOAD
・Unit settings or measurement data are transferred from the floppy disk or
PC card to the memory of the unit.
・When loading measurement data, the channel can be specified.
Method
1. Use the JOG control or the CURSOR keys to
select the desired file name.
2. Move the flashing cursor to the position
shown in the figure on the left, and use the
function keys to select LOAD.
3. Select either of the following loading methods.
: Deletes the waveform data from the unit and
load the new data.
: Load the new data by overwriting the
waveform data already in the unit.
: Cancel the load procedure.
: Change the channel from which to load.
: Change the channel from which to load.
・Data is not loaded to channels that are set to [ - ].
・In the example at left, analog data from CH 1 to 4
(none for CH 5 to 8) and logic data from CH A and
B (none for CH C and D) are saved to file.
・CH 1 data is loaded to CH 1 on the recorder, CH 3
data is loaded to CH 2, and CH A and B data is
loaded to CH A and B. (Data is not loaded from
CH 2 or 4.)
・Waveform data measured using an external sampling cannot be overwrite
and load.
・If the functions and/or time axis range of the data stored in the unit differ
from those of the data to be loaded, a warning message appears to disable
the overwriting and loading process.
・In the X-Y CONT recorder, recorder and memory, and FFT functions
(advanced version), the overwriting and loading function is not available.
To Next Page
Loading...
