6.5 Service
System reset
Method 1
1. Press the SYSTEM key to call up the Initialize screen.
2. Move the flashing cursor to the Sytem reset item and select Exec.
For details, see Section 9.7.3.
Method 2
Turn the unit on while holding down the STOP key.
・Gently wipe dirt from the surface of the unit with a soft cloth moistened
with a small amount of water or mild detergent.
Do not try to clean the unit using cleaners containing organic solvents such
as benzine, alcohol, acetone, ether, ketones, thinners, or gasoline. They may
cause discoloration or damage.
・Wipe the LCD gently with a dry, soft cloth.
・If damage is suspected, check the "Troubleshooting" section before
contacting your dealer or HIOKI representative.
・Pack the product carefully so that it will not be damaged during shipment,
and include a detailed written description of the problem. HIOKI cannot be
responsible for damage that occurs during shipment.
・Periodic calibration is necessary to verify and maintain accuracy. If
calibration becomes necessary, return the unit to us for maintenance.
To Next Page
Loading...
