Hioki 8835-01 - Page 374

APPENDIX4
────────────────────────────────────────────────────
Appendix 1 Error and Warning Messages
────────────────────────────────────────────────────
WARNING 330: Cannot set. (SHOT too long)
The recording length is too long for the memory
segmentation function or a waveform processing
calculation to be carried out.
WARNING 334: Cannot set. (AVERAGE)
The memory segmentation function cannot be set
together with the averaging function.
WARNING 335: Cannot set. (SEQUENTIAL)
Waveform processing cannot be carried out, because
memory segmentation function is active.
WARNING 336: Cannot set. (MULTI BLOCK)
Waveform processing cannot be carried out, because
memory segmentation function is active.
WARNING 337: Cannot set. (ROLL MODE)
Superimpose and waveform decision cannot be
carried out, because roll mode is active.
WARNING 338: Cannot set. (OVER LAY)
Waveform processing cannot be carried out, because
overlay function is active.
WARNING 339: Invalid. (STATUS) On the status screen, the key pressed is invalid.
WARNING 345: Cannot set. (AND logic
trigger)
’AND’ cannot be set between the trigger sources
using the logic trigger and the RMS level trigger
WARNING 346: Cannot set. (AND rms level )
’AND’ cannot be set between the trigger sources
using the RMS level trigger and the logic trigger.
WARNING 347: Invalid. (Pre Trigger) When the trigger is not set, the pre-trigger is invalid
.
WARNING 348: Invalid. (V-drop Trigger)
In the time axis range of 100 ms to 5 min, the
voltage drop trigger is invalid.
WARNING 351: Cannot set. (Free run)
The pre-trigger setting cannot be made, since all
trigger sources are switched off (free run).
WARNING 352: Invalid. (CHAN) On the CHANNEL screen, the key pressed is invalid
.
WARNING 353: Cannot set. (time/div:100ms-
5min)
The time axis range whithin which the voltage drop
trigger can be used is 100 μs to 50 ms/DIV.
WARNING 380: No data in Ref. Block
When using the memory segmentation function
(multi-block), there is no data in the reference block.
WARNING 381: Ref. block = Using block
When using the memory segmentation function
(multi-block), the reference block and the block
specified by the "using block" item are the same.
WARNING 382: No waveform data.
Because there is no waveform data present, it cannot
be displayed. Start measurement operation to
capture data.
WARNING 384: Different Ref. shot.
The recording lengths are different for the reference
block and the block specified by the "using block"
item. Capture data with the recording lengths set
the same.
WARNING 386: Invalid. (RECORDER) In the recorder function, the key pressed is invalid.
WARNING 387: Invalid. (X-Ycont)
In the X-Y recorder function, the key pressed is
invalid.
WARNING 388: No comparison AREA
No waveform evaluation area. Create waveform
evaluation area.
WARNING 389: Cannot use Printer.
The printer cannot be used when the time axis range
is 10 ms to 200 ms/DIV, and the recording length is
"continuous."
WARNING 390: Cannot set over up level. Setting cannot be higher than upper limit.
WARNING 391: Cannot set under low level. Setting cannot be lower than lower limit.