APPENDIX3
────────────────────────────────────────────────────
Appendix 1 Error and Warning Messages
────────────────────────────────────────────────────
16
17
18
19
5
6
7
8
9
10
11
12
13
14
A
APP
WARNING 94: Path name error.
Make sure that the path name does not exceed 127
characters.
WARNING 95: Empty directory name. Specify a directory name.
WARNING 96: Directory already exists.
A directory of the same name already exists. Change
the directory name.
WARNING 97: 2DD type FD.
The floppy disk is a 2DD media. Select the
appropriate disk format.
WARNING 98: 2HD type FD.
The floppy disk is a 2HD media. Select the
appropriate disk format.
WARNING 99: Conditions for OVERWRITE
are not satisfied.
Set the instrument’s measurement data, file function
and time axis range settings.
WARNING 201: Set printer paper. Printer paper has run out. Reload.
WARNING 202: Set printer lever.
The head up/down lever has been left in the up
position.
WARNING 207: AUTO RANGE failure
The auto ranging function has failed. Check the
input signal.
WARNING 208: Cannot SAVE. (Write
Protected)
Move the write-protect tab to the unset position.
WARNING 209: Cannot SAVE. (Disk Full) Delete files or use a different media.
WARNING 213: Invalid. (MEASUREMENT)
Pressed key is invalid, because parameter processing
is ON.
WARNING 214: Invalid. (Pre Trigger)
The pre-trigger cannot be set, because the additional
recording function is set.
WARNING 300: Cannot START. Cannot start measurement from SYSTEM screen.
WARNING 301: Invalid (SYSTEM) The key pressed is not valid on the system screen.
WARNING 310: Change auto print
When operating DC power supply, auto printing and
roll mode are set to ON, current cannot be tested in
more than 3 ch. Current testing in more than 3 ch
turned auto printing OFF.
WARNING 311: Change print
When operating DC power supply, printer is set to
ON, voltage cannot be tested in more than 3 ch.
Voltage testing in more than 3 ch turned printer
OFF.
WARNING 312: Cannot set. (Auto Print)
When operating DC power supply, auto printing
cannot be set, because current testing is set in more
than 3 ch.
WARNING 313: Cannot set. (Print)
When operating DC power supply, printer cannot be
set, because current testing is set in more than 3 ch.
WARNING 324: Ignore in running.
(AVERAGE)
Because averaging is used, waveform processing is
not carried out during the start operation.
WARNING 325: Ignore in running. (WAVE
CALC.)
Because a waveform processing calculation is carried
out, vernier adjustment cannot be carried out.
WARNING 327: Invalid. (COMPARISON)
Pressed key is invalid, when waveform evaluation is
being carried out.
WARNING 328: Invalid. (OVER LAY)
Operation is not possible, since the overlay function is
enabled.
WARNING 329: Wrong format for Comparison
Since the format is not SINGLE or XYsing, a
waveform decision is not possible.
To Next Page
Loading...
