Hioki 8835-01 - Page 372

APPENDIX2
────────────────────────────────────────────────────
Appendix 1 Error and Warning Messages
────────────────────────────────────────────────────
A
ppendix 1.1 Error Messages
ERROR 1: Set printer paper. Printer paper has run out. Reload.
ERROR 2: Set printer lever.
The head up/down lever has been left in the up position.
Lower it.
ERROR 11: Waint printer initiarize. Make sure that the external printer is ready to print.
ERROR 12: Set printer power on
Make sure that the external printer is connected or the
unit is powered on.
ERROR 13: Paper End Printer paper has run out. Reload.
ERROR 14: Printer Error. This indicates an internal printer error.
A
ppendix 1.2 Warning Messages
WARNING 70: Insert Floppy disk.
No disk is present in the floppy disk drive. Insert
one.
WARNING 71: Cannot load. (not 8835 data)
Data cannot be loaded, because it is not a set of data
created by the 8835-01.
WARNING 72: Illegal format.
The floppy disk is not a correctly formatted MS-DOS
disk, or is a 2DD, 640 KB format disk.
WARNING 73: Write Protected.
The floppy disk is write-protected. Change the write
-
protect setting or use a different disk.
WARNING 74: Disk full. There is insufficient space remaining.
WARNING 75: File is read only.
File cannot be written or deleted, because it is read-
only.
WARNING 76: General failure.
Access to disk is not possible because of some low-
level error, such as in formatting or file saving.
WARNING 80: Insert PC card. No card is present in the PC card slot. Insert one.
WARNING 81: Cannot load. (not 8835 data)
Data cannot be loaded, because it is not a set of data
created by the 8835-01.
WARNING 82: Illegal format.
The PC card is not a correctly formatted MS-DOS
disk.
WARNING 83: Write Protected.
The PC card is write-protected. Change the write-
protect setting or use a different card.
WARNING 85: File is read only.
File cannot be written or deleted, because it is read-
only.
WARNING 86: General failure.
Access to card is not possible because of some low-
level error, such as in formatting or file saving.
WARNING 90: File already exists.
File cannot be saved because a file of the same name
already exists. Change the file name.
WARNING 91: Directory full
Only a limited number of files and directories can be
created in the root directory.
WARNING 92: Directory not empty The directory is not empty. Delete files in it.
WARNING 93: Disk full Delete files or use a different media.