29
────────────────────────────────────────────────────
2.7 Loading Recoding Paper
────────────────────────────────────────────────────
Head up/down
lever
NOTE
7. Pull the recording paper to the outside through the printer exit slot in the
stock cover.
8. Close the stock cover, and finish by tearing off the recording paper against
the edge of the printer exit slot.
･ Always put the unit in the head up condition when it is to be transported or if
it is to be stored for a long period of time. If the unit is left to lie in the state
where the roller is being subjected to pressure by the head, then the roller
may become deformed or the characters may become uneven.
･ Particularly care should be taken not to put the recording paper in back to
front by mistake, because if this happens the waveform cannot be drawn.
･ Printing is not possible if the recording paper is loaded wrong-side up.
･ Do not insert it into the gap between the roller and the black sheet metal
portion.
･ Refer to the illustration to make sure that the correct side of the recording
paper is facing up.
･ Do this very carefully, because if the recording paper is slanted with respect to
the roller there is a danger that later a paper jam will occur.
To Next Page
Loading...
