Working with controlled APs
Discovery of controllers by controlled APs
6-18
Viewing all configured APs
To display information about APs configured by the controller, select Controlled APs >>
Overview > Configured APs.
The Configured APs page provides the following information:
Number of displayed access points: Number of configured APs that were discovered.
Filter APs by: To narrow down the list of APs in the table, select a category and enter
text on which to filter the AP list. Select Apply to activate the filter. To deactivate the
filter, clear the filter text and then select Apply.
Move selected APs to group: Select a group from the list and select apply to move all
selected APs in the table to that group.
Table
Select the title of a column to sort the entries according to the values in the column.
Check boxes: Use the check box to select an AP to move it to another group. Select the
check box in the title bar to select all APs on this page.
Detected:
Yes: The AP has been discovered and is listed on the AP overview page, where more
information is provided on the AP.
No: The AP has not been discovered.
AP name: Name assigned to the AP. Select the name to open its AP management page.
Serial number: Serial number assigned to the AP. Select the serial number to open its AP
management page.
Group Name: Group that the AP is part of.
Product: Product name of the MSM AP.
To Next Page
Loading...
Need help?
General
