Controller teaming
Creating a team
8-7
Configure connectivity and licenses on each controller
Use the management station to connect to each controller in turn and do the following:
1. Select Controller >> Maintenance > Licenses. Install the Premium license and any
required AP licenses. For information on how to install licenses, see Licenses on
page 20-6.
2. Select Controller >> Network > Ports.
3. Select LAN port. Set the static IP address as shown in the diagram.
Configure the team
On controller 2 and controller 3, do the following:
1. Select Controller >> Management > Teaming.
2. Select the Controller teaming checkbox.
3. Under Connectivity, set Communicate using to LAN port.
4. Select Save.
5. The Network Tree will no longer be visible. The Summary box will show Teaming with a
blinking gray status light. This indicates that the controller is searching for a team.
Once the controller successfully joins a team, the status light turns green.
On controller 1, do the following:
1. Select Controller >> Management > Teaming.
To Next Page
Loading...
Need help?
General
