Mobility traffic manager
Scenario 6: Distributing traffic using VLAN ranges
9-56
2. Select Add New VLAN.
Under General, set Port to LAN port.
Under VLAN, set VLAN ID to 10-30 (Net1).
3. Select Save.
Controller 2 configuration
Mobility domain
1. Select Controller >> Management > Device discovery.
(For complete screenshot see Defining the mobility domain on page 9-9.)
Select Mobility controller discovery.
Clear This is the primary mobility controller.
Set the IP address of the primary mobility controller to 192.168.5.2.
2. Select Save.
VSC
Configuration is the same as for controller 1.
To Next Page
Loading...
