HP MSM7XX

Authentication services
Using an Active Directory server
11-15
About the Default AC profile
The Default AC profile is always present and is always applied to all Active Directory
groups. You can use this profile to add additional attributes that are not configurable in an
account profile. Instead, these attributes are configured on the Controller >> Public access
> Attributes page. Once added there, they will automatically appear in the Effective
attributes list.
The following attributes can be added using this method:
Attribute For information, see
default-user-use-access-list Access list on page 15-34
default-user-welcome-url Default user URLs on page 15-55.
default-user-goodbye-url Default user URLs on page 15-55.
default-user-one-to-one-nat Default user one-to-one NAT on page 15-53.
default-user-idle-timeout Default user idle timeout on page 15-52.
default-user-session-timeout Default user session timeout on page 15-54.
default-user-acct-interim-update Default user interim accounting update interval on
page 15-51.
default-user-max-output-packets Default user quotas on page 15-52.
default-user-max-input-packets Default user quotas on page 15-52.
default-user-max-total-packets Default user quotas on page 15-52.
default-user-max-output-octets Default user quotas on page 15-52.
default-user-max-input-octets Default user quotas on page 15-52.
default-user-max-total-octets Default user quotas on page 15-52.
default-user-max-input-rate Default user data rates on page 15-53.
default-user-max-output-rate Default user data rates on page 15-53
default-user-bandwidth-level Default user bandwidth level on page 15-51.
default-user-use-public-ip-subnet Default user public IP address on page 15-54.