Icom VE-PG3 - M Selcall in Bridge Connection

5
BRIDGE MODE SETTING SCREEN
5-59
7. [Bridge Connection] Menu (continued)
M SelCall in Bridge Connection
Configure the rule of individual Callee destination in the Bridge mode.
The communication route is connected according to this setting.
q Index ……………………… The index assigned for the entry.
Setting range: “1” to “1000”
w Name ……………………… You can name the setting. (Up to 31 characters)
e Call Type ………………… Select the type of call.
• Individual : Call only specified radio.
• Group : Call all radios that belong to the specified group.
• All : Call all radios.
r Prefix ID …………………… Enter the prefix ID of the SelCall destination.
ID range: (Depending on the system mode)
t Destination ID …………… Enter the ID of the SelCall destination.
ID range: (Depending on the system mode)
Destination SelCall in Bridge Connection
y Address …………………… Enter the VE-PG3’s IP address which is connected to the radio that
communicates with the SelCall destination.
u Port Number ……………… Enter the VE-PG3’s port number which is connected to the radio that
communicates with the SelCall destination.
i <Add> …………………… Click to add a SelCall rule to the [SelCall in Bridge Connection List].
[Bridge Connection]–[SelCall in Bridge Connection]