Icom VE-PG3 - How to Initialize the VE-PG3

7
MAINTENANCE
7-6
About the initializing condition
• When “Restore to Factory Default” is selected:
You can restore all the VE-PG3’s settings. The VE-PG3’s IP address is set to “192.168.0.1,” when initialized. Set the PC’s
IP address to “192.168.0.xxx.” (You can set xxx to any number from 2 to 254.)
• When “Restore V/RoIP Settings to Factory Default” is selected:
In the Bridge mode : You can initialize only these VE-PG3’s items; [Operating Mode], [Bridge Connection],
[Port Settings] and [Expansion].
In the Converter mode : You can initialize only these VE-PG3’s items; [Operating Mode], [V/RoIP], [Extension
Connect], [Transceiver Connection], [Port Setings] and [Expansion].
Select the initialize option, and then click <Restore>.
2
There two ways to initialize the VE-PG3.
• Set the VE-PG3’s IP address again after the VE-PG3 is initialized.
A
Using the <INIT> button.
If you cannot access the VE-PG3 setting screen, initialize the VE-PG3 using the <INIT> button.
B
Initialize on the VE-PG3’s setting screen.
If you can access the VE-PG3 setting screen, initialize the VE-PG3 on the setting screen.
A
Using the <INIT> button
Initializing clears all the settings.
• If the network part of the PC IP address is different from that of the VE-PG3, you cannot access the VE-PG3 set-
ting screen. In such case, change the PC IP address according to your network environment.
See the supplied “Precautions“ leaflet for details.
5. How to initialize the VE-PG3
B
Using the VE-PG3’s setting screen
Click <OK>.
• The VE-PG3 automatically reboots.
3
w Click
Click
q Select
Click [Management], then [Factory Defaults].
• The [Factory Defaults] screen appears.
1