Icom VE-PG3 - M Voice Transmission Control to the Transceiver

5
BRIDGE MODE SETTING SCREEN
5-74
8. [Port Settings] Menu (continued)
M Voice Transmission Control to the Transceiver
The VOX (voice operated transmission) function automatically switches the connected transceiver to transmit,
when the VE-PG3 receives the audio signal through the network.
q Attack Time ……………… Enter the TX delay time in 5 milliseconds step. (Default: 50)
Range: 5 to 500 milliseconds
The voice delay is the amount of time the transmitter stays OFF after receiv-
ing a signal before the VOX switches to transmit.
w Release Time …………… Select the RX delay time in 5 milliseconds step. (Default: 500)
Range: 5 to 2000 milliseconds
It is the delay time for the VOX switch to turn OFF, after no audio signal is
received through the network.
e Voice Delay ……………… Set the audio signal buffer time to prevent intermittent audio in 5 milliseconds
step. (Default: 200)
Range: 0 to 500 milliseconds
The voice delay is the amount of time the VE-PG3 store the transmit audio to
prevent the beginning of the speech missing.
r Voice Threshold ………… Set the voice threshold level. (Default: 40)
Range: 0 to 100 %
The VOX function automatically switches between receive and transmit
according to this threshold level.
Lower values make the VOX function more sensitive to the audio signal.
* Appears only when “VOX” is selected in [Audio Transmission Methods to the Transceiver].
** Appears only when “VOX” or “RTP” is selected in [Audio Transmission Methods to the Transceiver].
[Port Settings]–[Transceiver 1 (TRX1)/[Transceiver 2 (TRX2)]
*
*
**