Icom VE-PG3 - M Bridge Communication

5
BRIDGE MODE SETTING SCREEN
5-88
8. [Port Settings] Menu (continued)
M Bridge Communication
Set the details of the input audio from the [EXT1]/[EXT2] port.
[Port Settings]–[EXT Input 1 (EXT1)/EXT Input 2 (EXT2)]
q Encryption ………………… Select “Enable” to encrypt the communication. (Default: Disable)
• When you select "Enable," enter the appropriate key to [ Encryption Key].
Default Callee ID
w Default Callee ID ………… Select “Enable” to apply the ID to the TX signal. (Default: Disable)
• When you select "Enable," enter the IDs in the below items.
e Call Type ………………… Select the type of call. (Default: Group)
• Individual: Call only specified radio.
• Group: Call all radios that belong to the specified group.
• All: Call all radios.
r Destination Prefix ID …… Enter the destination prefix ID.
ID range: (Depending on the system mode)
t Destination ID …………… Enter the destination ID. (Default: 1)
ID range: (Depending on the system mode)
y My Station Prefix ID ……… Enter the station prefix ID.
ID range: (Depending on the system mode)
u My Station ID …………… Enter the station ID. (Default: 1)
ID range: (Depending on the system mode)
*Appears when “Enable” is selected in [Default Callee ID].
*