Icom VE-PG3 - Page 149

5
BRIDGE MODE SETTING SCREEN
5-87
M Digital Transceiver Communication
Mode: dPMR Mode2
Set the calling details.
q Talk-Back ………………… Select “Enable” to enable the Talk-Back. (Default: Enable, 5 (seconds))
• When you select "Enable," select the Talk-Back Time between 1 and 10
(seconds).
w Digital SQL ……………… Select “Enable” to enable the digital squelch. (Default: Disable)
e RX All Call ………………… Select “Enable” to permit all talkgoups to receive the call.
(Default: Disable)
Default Callee ID
r Call Type ………………… Select the type of call. (Default: Group)
• Individual: Call only specified radio.
• Group: Call all radios that belong to the specified group.
• All: Call all radios.
t Destination ID …………… Enter the destination ID. (Default: 100000)
ID range: (Depending on the system mode)
8. [Port Settings] Menu (continued)
[Port Settings]–[Digital Transceiver 1 (D-TRX1)]–
[Digital Transceiver 4 (D-TRX4)]
M Digital Transceiver Control
Mode: dPMR Mode2
Set the calling details.
Release Time ……………… Select the RX delay time in 100 milliseconds step. (Default: 200)
Range: 200 to 1000 milliseconds
It is the delay time for the VOX switch to turn OFF after no audio signal is
received.