Icom VE-PG3 - M Voice Transmission Control to the EXT Device

5
BRIDGE MODE SETTING SCREEN
5-100
8. [Port Settings] Menu (continued)
M Voice Transmission Control to the EXT Device
Set the audio output control details for the [EX1T]/[EXT2] port.
• This setting item appears when "Control Output Circuit" is selected in [Control Circuit Change].
q
Audio Transmission Methods to the EXT Output Device
Select the Audio Transmission Method. (Default: RTP)
• VOX: Sends the audio signal and enables the PTT, when the
input audio signal level exceeds the threshold level.
• RTP: Sends the audio signal and enables the PTT, while
receiving the RTP packet,
• PTT Always-on: Always sends the audio signal to the radio and enables
the PTT.
• PTT Always-off: Always sends the audio signal to the radio and disables
the PTT.
w Attack Time ……………… Enter the TX delay time in 5 milliseconds step. (Default: 50)
Range: 5 to 500 milliseconds
It is the delay time before the VOX switch turns ON after an audio signal is
received through the network.
e Release Time …………… Select the RX delay time in 5 milliseconds step. (Default: 200)
Range: 5 to 2000 milliseconds
It is the delay time for the VOX switch to turn OFF after no audio signal is
received through the network.
r Voice Delay ……………… Set the audio signal buffer time to prevent intermittent audio in 5 milliseconds
step. (Default: 5)
Range: 0 to 500 milliseconds
t Voice Threshold ………… Set the voice threshold level. (Default: 40)
Range: 0 to 100 %
The VOX function automatically switches between receive and transmit
according to this threshold level.
*Appears only when “VOX” is selected in [Audio Transmission Methods to the Transceiver].
Control Circuit Change:Control Output Circuit
[Port Settings]–[EXT Output 1 (EXT1)/EXT Output 2 (EXT2)]