Icom VE-PG3 - M Digital Transceiver Control

6
CONVERTER MODE SETTING SCREEN
6-87
9. [Port Settings] Menu (continued)
M Digital Transceiver Control
Configure the details for digital transceiver control.
q PTT Cancel ……………… Select “Enable” to abort the calling to an IP phone when a transmit request is
detected. (Default: Disable)
w Timing of
Target Availability Check … Select “Before” to execute the Target Availability Check before the
communication route is established. (Default: After)
Notice Tone to the Transceiver
e Reception Notice ………… Select “Tone 1” to “Tone 3” to notify that the call from an IP phone is received.
(Default: None)
r Calling Notice Tone ……… Select “Tone 1” to “Tone 3” to notify the calling to an IP phone.
(Default: Notice Tone 2)
t Send Connect Success Tone Select “Tone 1” to “Tone 3” to notify that the IP phone’s handset is picked up.
(Default: Notice Tone 2)
y Disconnect Notice Tone … Select “Tone 1” to “Tone 3” to notify that the IP phone’s handset is put.
(Default: Notice Tone 3)
[Port Settings]–[Digital Transceiver1 (D-TRX1)–Digital Transceiver4 (D-TRX4)]
!1